ASNU35 SINGLE WAY BEARINGS 35x80x31mm
The ASNU35 bearing is a Single Way Bearing&Cluth with an inner diameter of 35 mm , an outer diameter of 80 mm, a width of 31 mm. It typically uses P0(ABEC-1), P6(ABEC-3), P5(ABEC-5) grade precision tolerances and OPEN type, together determine its load-bearing capacity, rotational accuracy, and applicable working conditions.
Type ASNU is a roller type freewheel non-bearing
supported. Bearings are required to support axial
and radial loads. Lubrication and sealing must also be
provided by the installation. Nominal outer diameter is the
same as a series 63.. ball bearing.
A typical arrangement is to install this type alongside
a bearing within the same location tolerances, as shown
on the following page. The inner race is keyed to the shaft.
The outer race has positive n6 tolerance, to give a press fit
in a H7 housing. Additional side notches in the outer race
provide for positive torque transmission.
If the housing is to K6 tolerance, use of the notches is
not necessary, but the housing must be strong enough to
not expand after assembly. This design can accept an axial
misalignment of inner and outer race of Å} S/2.
Share this product to:
Let more people see your product
-
- CSK40PP SINGLE WAY BEARINGS 40x80x27mm
- CSK40PP SINGLE WAY BEARINGS 40x80x27mm 1 Ability to carry heavy loads 2 Less coefficient
-
- ASNU35 SINGLE WAY BEARINGS 35x80x31mm
- ASNU35 SINGLE WAY BEARINGS 35x80x31mm 1 Ability to carry heavy loads 2 Less
-
- DC5476B(4C)-N SINGLE WAY BEARINGS 54.765x71.425x21mm
- DC5476B(4C)-N SINGLE WAY BEARINGS 54.765x71.425x21mm 1 Ability to carry heavy loads 2 Less